Is A Tube Amp Worth It?

What’s the difference between a tube amp and a regular amp?

On a technical level, the difference between the two types of amps is very simple: tube amps use vacuum tubes to amplify a guitar signal, while solid state amps use electronics to provide amplification.

The sound of solid state amps depends largely on the exact circuitry of the amp..

Why are tube amps so expensive?

Tube amps are expensive because they adopt pre and power tubes as their primary amplification source. Each tube costs roughly $50 and can have up to 4 of them within a single unit. Secondly, these amps have more expensive components, larger cases, and more complex circuitry than solid-state amps.

How long do tube amps last?

about 5,000 to 10,000 hoursDepending on how often you turn on and turn off your gear, but tubes should last about 5,000 to 10,000 hours. For most people, they only need to be replaced every 2-3 years at most. But it’s good to have at least a spare set around just in case one of them decides to die on you.

Why do tube amps sound better loud?

Because valve/tube amps have an output transformer causes the amp to have a ‘high output impedance’. … This is a form of distortion, as the speaker is not following exactly the signal the amplifier is feeding to the speaker. This is the only reason a tube amp ‘can’ sound louder than a elderly transistor amp design.

Why do tube amps sound better than solid state?

Tubes sound better because their distortion products are more musical. … Those are the fundamental reasons why tubes simply sound better. Vacuum tubes are the more linear and require less feedback. Tubes are voltage amplifiers as opposed to transistors which are current amplification devices.

How long should you warm up a tube amp?

20 to 30 minutesIt is important, too, that the warmup that you give your tube amp is very thorough. If they are not warmed up properly, the tone of your playing will not be as good as it ought to be. As a rule of thumb, your tube amp needs to be warmed up for 20 to 30 minutes at least before you can start playing your guitar.

Why do vintage amps sound better?

If you mean guitar amps, they usually sound better because they were handmade (sturdier wiring in particular helps), and build quality aids sound quality. … They are all “solid state” AKA transistor amps. If we are talking home music systems, the reason for the old amplifiers sounding better is simply build quality.

Should I get a tube or solid state amp?

Tube amps are generally more expensive in initial cost and to operate (because you need to replace the tubes occasionally), and solid-state amps are generally less delicate and more reliable. Many players, however, feel that tube amps yield a warmer, more musical tone and more musical-sounding distortion.

How do you maintain a tube amp?

Tips for Tube Amp CareTry to let your amp warm up some before use. … If you replace output tubes always replace the whole set, preferably with tubes of the same make. … If possible, always allow the amp to cool down 15 or so minutes before moving it.Always use high quality signal and speaker leads and check them regularly.More items…•

Are solid state amps better for metal?

Solid-State Metal Tone. If you play heavy metal or hard rock you need an amp that gets you high-gain sounds with outstanding tone. … For one thing, solid-state guitar amps tend to be much more reliable than tube amps.

Are tube amps really better?

Tube amplifiers sound better because of the euphonic distortions they add to the music, as well as plenty of other reasons I’ll cover below. … The ways that tubes distort when pushed to the edge are much more musical than the artificial sounds that come from transistor amplifiers when overdriven.

What does a tube do in an amp?

A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.

How long do solid state amps last?

Well-made piece should last at least for 50 years with proper use and care and with maybe some not very big repaires every 15 years or so. That’s pretty good. And tube amp should last 150 years, I would guess.

Is 15 watts loud enough to gig with?

15 watts is probably loud enough to be heard over most drummers, but it will be too quiet in a full band. 25W ad up will get you loud enough while still having some headroom for cleaner tones. As previously stated 15-20 works but not much cleans.

How loud is a 100 watt amp?

It depends on the speakers but I would say a 100 watt full stack (at 1 meter away) is about 125 dB. 50 watt half stack is about 120 dB. That’s about it.